Epoxy BS 2000 Clear

Product specifications

Component A

Density (20°C)1.01 g/cm³

Viscosity (25 °C)100 mPa s

Component B

Density (20°C)1.14 g/cm³

Viscosity (25 °C)800 mPa s

Mixture

Density (20°C)1.05 g/cm³

Viscosity (25 °C)105 mPa s

AppearanceYellowish

The stated values represent typical product characteristics and are not to be construed as binding product specifications.

‍

Preparation

Substrate requirements

• The substrate must be firm, dimensionally stable, capable of bearing loads and free of loose constituents, dust, oil, grease, rubber marks and other substances that could interfere with adhesion.
• The tensile strength of the surface of the substrate must be at least 1.5 N/mm² on average (smallest individual value of at least 1.0 N/mm²), and the compressive strength must be at least 25 N/mm².
• Substrates must have reached their moisture balance and must also be protected against moisture penetration from the reverse side, including during use.
• Concretemax. 6 m% moisture
• Cement screedmax. 6 m% moisture
• Anhydrite screedmax. 0.3 m% moisture
• Magnesite screed2-4 m% moisture
• In the case of anhydrite and magnesite screeds, moisture cannot be permitted to penetrate from building elements or the ground.
• As a general principle, systems which permit the diffusion of water vapour are recommended for use with anhydrite and magnesite screeds.

Preparations

• Prepare the substrate by suitable means, e.g. steel shot blasting, so that it meets the specifications listed above.
• Broken out or missing areas in the substrate should be filled flush with the surface using Remmers PCC systems or Remmers EP mortars.

Preparation

Combination container

• Add the entire quantity of the hardener (component B) to the base compound (component A).
• Mix thoroughly with a slow-speed electric mixer
  (approx. 300 - 400 rpm).
• Pour the mixture into a separate container and mix again thoroughly.
• Mix for at least 3 minutes.
• Insufficient mixing is indicated by streaks forming.
• When using on highly absorbent substrates, mix the product with up to 20% by mass of water as necessary.

Application

Application requirements

• Temperature of the material, air and substrate: from min. +8 °C to max. +30 °C
• The times given are reduced at higher temperatures and increased at lower temperatures, in particular in combination with high humidity.

Working tools / cleaning

• Brush, rubber scraper, epoxy roller, mixer
• More detailed information can be found in the Remmers Tool Programme.
• Clean tools, equipment and any splashed material immediately with water while still fresh.
• Take suitable protective and waste disposal measures when cleaning.

Storage / shelf life

• If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

‍